I think I have to send my device in, how do I proceed? What do I have to do when I send my unit to Waldorf from outside the European Union?
HA-ALLE // First, make sure you've tried all the procedures above that are related to your issue.
How can I update the firmware of the kb37?
This requires several steps. Please refer to page 19 of the English manual which is
How many modules can I fit into my kb37?
That depends on the size of your modules. The opening in the kb37 is 543mm/107HP
How much current does the power supply deliver?
The power supply delivers +12v and -12v to the power board inside kb37. Each of
The controls for the arpeggiator direction are switched!
Please refer to section 11 on page 19 of the manual on how to do
How can I link the internal Gate and Pitch signal to the bus board?
Switch off and disconnect your KB37 from mains power. Remove the leftmost module(s) from the
The pitch wheel or mod wheel does not work correctly. How can I calibrate the pitch bend and mod wheel?
HA-KB37 // Please refer to section 9.5 of the manual (EN: page 16), which is available in the download section.
Which cable do I need to connect my modules?
Make sure to switch off the kb37 and remove the power plug before installing or
Where’s the +5V power on the bus board?
There is no +5v power on the bus. Since only few devices need that, we
Which screws do I need?
You will need metric M3 screws to install your modules.
