How much current does the power supply deliver?
The power supply delivers +12v and -12v to the power board inside kb37. Each of
The controls for the arpeggiator direction are switched!
Please refer to section 11 on page 19 of the manual on how to do
How can I link the internal Gate and Pitch signal to the bus board?
Switch off and disconnect your KB37 from mains power. Remove the leftmost module(s) from the
The pitch wheel or mod wheel does not work correctly. How can I calibrate the pitch bend and mod wheel?
HA-KB37 // Please refer to section 9.5 of the manual (EN: page 16), which is available in the download section.
Which cable do I need to connect my modules?
Make sure to switch off the kb37 and remove the power plug before installing or
Where’s the +5V power on the bus board?
There is no +5v power on the bus. Since only few devices need that, we
Which screws do I need?
You will need metric M3 screws to install your modules.
What is the “colour” feature of the dvca?
This parameter changes the timbre of the audio routed through the dvca1. The more the
What does the cmp1 do?
cmp1 is a compressor that makes incoming signals fat, crispy and warm. Unlike a traditional
What makes the mod1 so special?
mod1 consists of an ADSR envelope with up to three decay stages which can be
