Is it normal that my new Pulse2 just freeze in some situations ?

More
2 months 2 weeks ago - 2 months 2 weeks ago #1 by csurieux
Just bought new, last firmware.
When I use it more as an expander, using preset 101, Digital 2 if I remember correctly, This preset is using arpeggios.
I send to pulse midi notes translated from an electric guitar playing chords and arpeggios, on a dedicated midi channel, no real time event, some midi CC 7 to adjust output level.
Very good sounding but, after several minutes of playing (recording) , from time to time, Pulse 2 stops following and emitting sounds and I must switch it off/on to bring it back.

What could be the reason ?
Am I using it in uncertain territory ?
I must say that my Blofeld and MicroFreak have no problems in  same situation ???

It is annoying.
 
Last edit: 2 months 2 weeks ago by csurieux.

Please Log in or Create an account to join the conversation.

  • Qwave
  • Qwave's Avatar
  • Away
  • Elite Member
  • Elite Member
  • longtime Waldorf enthusiast
More
2 months 1 week ago #2 by Qwave
No such problems here. But I am not using a electric guitar as controller.

You use just the MIDI In of the Pulse2? Nothing at the MIDI out? No USB used?
Just to check if it is caused by a MIDI loop.

Please Log in or Create an account to join the conversation.

More
2 months 1 week ago - 2 months 1 week ago #3 by csurieux
Yes just midi over usb in ,no loop because all my synts are connected to an IConnectivity MIOXL which filters and routes safely.
I will recheck the routing / mapping but Pulse 2 is on its own midi channel and emitting no midi ?
Last edit: 2 months 1 week ago by csurieux.

Please Log in or Create an account to join the conversation.