Is it possible to have modulators work on the absolute value?

Mehr
5 Monate 3 Wochen her #1 von dcardani
I would like to tie the X-Y pad position to a few different parameters. However, some of the parameters are bipolar and some are unipolar. What I would like to achieve is to have the amplitude of one oscillator be at full volume when the X-Y Pad is centered at, say X = 0, and have it be at the lowest volume if X = +/-1. Is that possible to set up either in the modulation matrix or some other setting? I don't want to have the X portion of the X-Y pad be unipolar because I want to tie both amplitude and wave table position, for example, to the X position, and I want the position to be able to go negative.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
5 Monate 3 Wochen her - 5 Monate 3 Wochen her #2 von paulinwales
This works:

set osc mix knob to 100%
mod pad x > osc mix > amount = 0%
controller=mod pad x >control amount = -100%

this has full volume at 0, but lowers volume going positive or negative on the x axis

the reverse has 0% at mid, and goes higher at either ends of the x-axis:

set osc mix knob to 0%
mod pad x > osc mix > amount = 0%
controller=mod pad x >control amount = +100%
 
Letzte Änderung: 5 Monate 3 Wochen her von paulinwales.
Folgende Benutzer bedankten sich: dcardani

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
5 Monate 2 Wochen her - 5 Monate 2 Wochen her #3 von paulinwales
In case it's not clear why this works:

Modulation=Source x (amt + (controller x controller amt))

source and controller are the same, so using -1 to +1 instead of -100% and 100% for clarity:

With ctrl amt = -100% (-1):
src x ( 0 + (cntrl x cntrl amt))
-1 x ( 0 + (-1 x -1)) = -1
+1 x (0 + (+1 x -1)) = -1

With ctrl amt = +100% (+1):
src x ( 0 + (cntrl x cntrl amt))
-1 x (0 + (-1 x +1)) = +1
+1 x (0 + (+1 x +1)) = +1
Letzte Änderung: 5 Monate 2 Wochen her von paulinwales.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
5 Monate 1 Tag her #4 von dcardani
I thought I had replied to this to say that it works great! Thanks for the tip!

Bitte Anmelden oder Registrieren um der Konversation beizutreten.