10years Blofeld - need to replace encoders, how-to ?

Mehr
1 Jahr 11 Monate her #1 von mk2_13
hello,

where can i buy the exactly sames encoders ? i'll replace myself..

If i ask Waldorf, how much it costs + delivery ? (i live in France)

thx !

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
1 Jahr 11 Monate her #2 von mk2_13

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
1 Jahr 6 Monate her #3 von ben74
As a Blofeld DT user, I was expecting this forum to contain loads of similar posts and at least _some_ feedback/info from Waldorf on where/how to proceed to get the newer encoders but all I found is this post...

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
1 Jahr 3 Monate her #4 von mk2_13
bought 10 of this :

www.digikey.fr/product-detail/fr/bourns-...20F-N0024-ND/3534269

it's the same.

these ones :

www.digikey.fr/product-detail/fr/bourns-...20F-N0024-ND/3534215

have "cran" (steps) if u prefer, but the original model (1st link) is better.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
1 Jahr 3 Monate her #5 von Zaphod Betamax
With the Blofeld keybed I found it quite tough to get the motherboard out and in after doing the work.
Aligning all the buttons and LEDS is also quite tough.

Not sure if as difficult with the module though

Bitte Anmelden oder Registrieren um der Konversation beizutreten.

Mehr
1 Jahr 3 Monate her #6 von brentUS
Do the encoders listed here have the oil contamination tendency which I read is the cause for the skipping/non-responsiveness of the encoder? Thank you.

Bitte Anmelden oder Registrieren um der Konversation beizutreten.